10CAG/10CHG/10CGGHz CHANNEL RADIO CONTROL SYSTEM INSTRUCTION MANUAL Technical updates and additional programming examples. Instruction manual • Read online or download PDF • Futaba 10CG GHz User Manual. Futaba 10CHG Pdf User Manuals. View online or download Futaba 10CHG Instruction Manual.
|Published (Last):||11 June 2018|
|PDF File Size:||7.21 Mb|
|ePub File Size:||15.47 Mb|
|Price:||Free* [*Free Regsitration Required]|
If you need to remove or replace the transmitter battery, do not pull on its wires to remove it.
Stick Adjustments Adjusting the length of the non-slip control sticks You may change the length of the control sticks to manhal your transmitter more Stick tip A Locking piece B comfortable to hold and operate. It is recommended to have your Futaba equipment serviced annually during your hobby’s “off season” to ensure safe operation.
Elevator-to-flap, Rudder-to-aileron, flap-to-elevator, and other programmable mixes p. A single long beep.
Futaba 10CHG Manuals
Next, move the locking piece B up or down to lengthen or shorten. Those functions which are identical to the ACRO setups are referred directly to those pages.
Switches for which warnings will be issued at power-up are listed below: This 10hg may be used for model airplane or surface boat, car, robot use. Dual rates affect the control listed, such as aileron, not just a single ex: Not displayed if master is not CHbecause have futabq trim.
Center the trims on the transmitter, then find the arm that will be perpendicular to the pushrod when placed on the servo. May also be used creatively to create mahual delayed servo on a different function see www. The Logic switch can be assigned to the following functions: Defaults to ACRO model type.
Mounting the GV-1 to the counter gear instead of the fan Setting example: For details on setting up a complex aerobatic plane, please visit www.
Operating instructions FUTABA 10CHG
Now you’ll Using a small Phillips screwdriver, rotate the adjusting screw for each stick for the desired spring tension. Each transmitter has an 10cbg assigned, unique ID code.
Chapters Table Of Contents When using the CAMPac, the information will be displayed. Page 64 display changes if new setting futabx different from prior setting.
Operating instructions FUTABA 10CHG |
Always use an extension of the proper length. Page See Twin elevator servos. Prior to setting up THR-HOLDhook up the throttle linkage so that the carburetor is opened fully at high throttle, then use the digital trim to adjust the engine idle position. Note that if the power switch is turned off prior to completion, the data will not be copied.
Knobs and sliders on the Fasten about cm from the servo outlet so that the lead wire is neat. First, remove the battery cover on the rear of the transmitter. It’s a community-based project which helps to repair anything.
FUTABA 10CAG Instruction Manual
The 10CG may be master or student with any Futaba transmitter compatible with the cord. Using Twin Aileron Servos: Setting up the Normal Flight Condition: Refer to a Futaba catalog for 10chf information: Page of Go. Charger The initial charge, and any charge after a complete discharge, should be at least 18 hours to ensure full charge.
Data cannot be converted from 8U or 9Z memory types.
To prevent possible damage to your radio gear, turn the power switches on and off in the proper sequence: If there are some FASST transmitters turned on near the receiver, the LED may show the above status for a brief moment before changing to the status indication as shown in the “LED indication” table above.
Adjusting the length of the non-slip control sticks You may change the length of the control sticks to make your Receiver Ni-Cd battery You should fully discharge your system’s NiCd batteries periodically to prevent a condition called “memory”.